Portwest AP31 Senti Cut Lite Gloves
 Portwest AP31 Senti Cut Lite GlovesPortwest AP31 Senti Cut Lite Gloves 

Portwest AP31 Senti Cut Lite Gloves

 

Size:  
 

Product Code:  AP31
Brand:  Portwest

Portwest

Portwest AP31 Senti Cut Lite Glove

The lightweight 18 gauge cut 3 liner boast superior dexterity offering a "second skin" feel. The PU palm coating offers secure grip in dry and light oily handling environments. This glove is extremely hardwearing with a soft breathable liner. Elastic knitted cuff provides a secure and comfortable fit.

EN 420, EN 388, EN 388:2016

 

 

Protective Gloves : General Requirements

EN420 : 2003 + A1 2009

This standard defines the general requirements for glove design and construction, innocuousness, cleaning instructions, electrostatic properties, sizing, dexterity, water vapour transmission and absorption along with marking and information

EN 388

Gloves giving protection from mechanical risks
Protection against mechanical hazards is expressed by a pictogram followed by four numbers (performance levels), each representing test performance against a specific hazard.

1 Resistance to abrasion
Based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below.

2 Blade cut resistance
Based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4.

3 Tear resistance
Based on the amount of force required to tear the sample. 
The protection factor is then indicated on a scale from 1 to 4.

4 Puncture resistance
Based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.

EN 388:2016 ONLY
EN 388:2003 Standards specifies physical and mechanical aggression caused by abrasion, blade cut, tearing and puncture. EN388:2016 updates the existing standard with this new test method for abrasion, blade cut & impact resistance. EN ISO 13997:1999 (TDM Test) records cut results as a Newton value – the force of the blade on the glove material needed to cut through the material 20mm. The results are represented on a scale A-F.

5 Straight blade cut resistance EN 388:2016 ONLY
Based on the amount of force to achieve the moment of cut-through. The protection factor is then indicated on a scale from A to F

6 Impact resistance EN388:2016 ONLY
Impact-resistant properties to 5J, Performance Level P

Click here to learn more about EN Standards

Basket
Basket: (0) £0.00
BK Safetywear trade
30,000+ SKU's
Fast Reliable Service
Wholesale Prices