NEW
Portwest A112 Heavyweight Polka Dot Gloves - PVC

Portwest A112 Heavyweight Polka Dot Gloves - PVC

 

  
 

Product Code:  A112
Brand:  Portwest

Portwest

The Portwest A112 Heavyweight Polka Dot Glove is perfect for a range of heavy duty handling tasks with added contact heat resistance.

EN 420, EN 388, EN 407

Protective Gloves : General Requirements

EN420 : 2003 + A1 2009

This standard defines the general requirements for glove design and construction, innocuousness, cleaning instructions, electrostatic properties, sizing, dexterity, water vapour transmission and absorption along with marking and information

EN 388
Gloves giving protection from mechanical risks

Protection against mechanical hazards is expressed by a pictogram followed by four numbers (performance levels), each representing test performance against a specific hazard.

1 Resistance to abrasion
Based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below.

2 Blade cut resistance
Based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4.

3 Tear resistance
Based on the amount of force required to tear the sample. 
The protection factor is then indicated on a scale from 1 to 4.

4 Puncture resistance
Based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.

Protective Gloves Against Thermal Risks (Heat and/or Fire)

EN 407: 2004

This standard specifies thermal performance for protective gloves against heat and/or fire. The heat and flame pictogram is accompanied by a 6 digit number.

Requirements

Performance levels 1-4

f) resistance to a large melting metal spray

Amount of spray required to raise the glove to a certain temperature.

Performance levels 1-4

e) resistance to small melting metal spray

Amount of spray required to raise the glove to a certain temperature.

Performance levels 1-4

D) resistance to radiating heat

Time required to raise a given temperature level

Performance levels 1-4

c) resistance to convective heat

time during which the glove is able to delay the transfer of heat of a flame

Performance levels 1-4

b) resistance to contact heat

Temperature (within the range of 100 degrees to 500 degrees) at which the person wearing the gloves will not feel any pain (for a period of at least 15 seconds).

Performance levels 1-4

A) Resistance to flammability:

Time during which the material remains lit and continues to be consumed after the ignition source has been eliminated.

Click here to learn more about EN Standards

Basket
Basket: (0) £0.00
BK Safetywear trade
30,000+ SKU's
Fast Reliable Service
Wholesale Prices